Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

DHCP 242 boot Loop - SE 10.1 2

Status
Not open for further replies.

Karlcom

Technical User
Dec 2, 2016
31
GB
I'm trying to configure ethernet pass-through on an Avaya 9608 handset. I'd like voice to be on VLAN 700 and data on VLAN 1.

Setup:

* DHCP 242 string: MCIPADD=192.168.0.10,MCPORT=1719,HTTPSRVR=192.168.0.10,L2Q=0,L2QVLAN=700,VLANTEST=0

* Phone is connected to a trunk port with VLAN 1 (staff) untagged and VLAN 700 (voice) tagged

* Firewall has an any-any rule from staff subnet (192.168.2.1/24) to voice subnet (192.168.7.1/24)

This seems to work and I'm able to login to the phone, however after about a minute the machine reboots and gets stuck in a loop until I either manually clear it or change the switchport config so that only VLAN 700 is supported.

Does the L2Q need to be set to a different number?

Assistance would be much appreciated. thank you.
 
Thank you for the reply Lem0n.

What do you mean by staff Vlan? is that what the 1 means?
 
@Karlcom. Your own words "VLAN 1 (staff)"

Stuck in a never ending cycle of file copying.
 
Hi sizbut,

Oh yes, my mistake. haha. Thank you both for your time.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top