Determine amount of T1

[kattr11]

Nortel Option 61

What is the easiest way to determine how many T1's are in my sytem and what they are for (local or long distance)?

 

[bigindian65]

prt CEQU in ld 22

prt RDB in ld 21

prt a few NXX & NPA in 90 look at common RLI

prt RLI in 86, see entry 0 route



Mato' Was'aka

 

[acewarlock]

Get a Vendor.




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.

 

[pronei]

LD 60
stat

This will prnt all configured loops (t1's) you have and their status.

LD 21
LTM

This will tell you which of those loops are used in which routes

LD 90
prt
net
ac1
npa 1XXX (XXX = a LD area code)

Take note of the RLI for that NPA you just printed.

LD 86
PRT
RLB
RLI X (X = the RLI from previous step)

Take note of the ROUT entry from that list. That is your LD route.

LD 21
PRT
RDB X (X = ROUT entry from previous step)

This will print the Route info

 

[Triton101]

I would suggest to look at your Telecom Bill to see the brake down of what you are paying for. We had a customer that was paying for 4 T1s but they only had 3 plugged in and programmed.... they never setup the 4th.....

So if you find the programming as suggested above on the PBX, also check your bill......

 

[kattr11]

Thank you PRONEI. Your post was what I needed.

 

[acewarlock]

Even doing all of the above, there is no gaurantee that it is right.




This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.