Denial event 1204

[ssaleem1]

hi,

Call doesn't go through with the following logs.


12:41:12 active station 5457 cid 0x2c7
12:41:12 G711A ssff ps:20
rgn:1 [10.1.6.97]:49776
rgn:1 [10.1.3.6]:8774
12:41:19 dial 92541804# route:ARS
12:41:19 term trunk-group 88 cid 0x2c7
12:41:19 dial 92541804# route:ARS
12:41:19 route-pattern 1 preference 1 cid 0x2c7
12:41:19 seize trunk-group 88 member 56 cid 0x2c7
12:41:19 Calling Number & Name NO-CPNumber NO-CPName
12:41:19 Setup digits 2541804
12:41:19 Calling Number & Name 4405457
12:41:19 Proceed trunk-group 88 member 56 cid 0x2c7
12:41:19 denial event 1204: Bearer cap not implem D1=0x928 D2=0x241


regards,

 

[montyzummer]

so first off cm build hardware etc ect

below is a description of your fault but what trunks are you using how often etc


Cause Value 66
[0x42/0xC2] Channel type not implemented
The call could not be completed because the equipment sending this Cause Value does not
support the channel type requested in the SETUP message.
This Cause Value has end-to-end significance and should always be passed back through the
network to the user.
Troubleshooting
• Check the diagnostic information (DIAG) for the unsupported channel type. See
Cause Values and their meanings/interpretations on page 11.
• Check Communication Manager administration (network generated Cause Value):
- Communication Manager is attempting to make a wideband call over an interface to an
ISDN network that does not support wideband calls. Check the trunk group and routing
translations to be sure the attempted call has not inadvertently been routed to this
interface or was mis-classified as a wideband call.
• Communication Manager administration that can affect sending of this Cause Value:
- The network is supporting wideband calling and Communication Manager does not have
wideband support enabled on the Wideband Switching field on the
system-parameters customer-options screen
- Communication Manager does not have wideband support enabled on the
Wideband Support field on the appropriate trunk group
- The trunk group does not have the correct type(s) of wideband channels enabled
- Communication Manager does not have the right size wideband endpoint programmed.

APSS (SME)
ACSS (SME)
ACIS (UC)