Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Deleting Span From The HiPath

Status
Not open for further replies.

Mechjet

MIS
Mar 4, 2010
19
US
Hello All,
At one of my locations I have two PRI's connected to the DIU2U card. I am in the process on disconnecting one of the circuits and was wondering if anyone could tell me the AMO command of removing the channels from the Trunk Group and deleting the setup of that span from the system. Any feedback would be greatly helpful.
Thank you.
 
first find the circuit

REG-TDCSU;

when you find which circuit it is then deactivate it.

DEA-DSSU:L,PEN,X-X-X-X;

then

DEL-TDCSU:X-X-X-X;

if it does not delete then you have it setup in a trunk group on its own.

let me know how you get on
 
Thank you for the help. I will try the AMO commands once the circuit has been disconnected from Telco.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top