Deleting connectors

[Guest_imported]

I have a question.
I have a visio diagram which contains lot of blocks and lot of conneectors. I want to retain all the connectors connecting to five of these blocks and delete all other connectors. (Connectors which do not connect to any of these five blocks).
Is there any easy way of doing it ? . Now i am doing it this way.
I click on each connector, if it connects to any of the five blocks, retain it, else delete it.

Is there a better way of doing it ? . Therea are about 400 connectors in total. so it is difficult to select each connector and check.

 

[ddavids]

If you go to Edit menu, then Select Special, you can select the connector layer. After that, you can deselect the appropriate connectors by holding down the Shift key and clicking on those you want to keep.