Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

deleting commands on a 4500 series switch 3

Status
Not open for further replies.

damocles13

Technical User
Apr 27, 2009
26
US
I have an 4507R with a port that does not need the residual commands left by previous admins.
interface FastEthernet6/12
description HR Rm215 P639
switchport access vlan 10
switchport trunk native vlan 999
switchport mode access
speed 100
duplex full
qos trust dscp
tx-queue 2
bandwidth percent 30
shape percent 30
tx-queue 3
bandwidth percent 75
priority high
How do I rid the commands after "duplex full" form the switch? Thanks in advance!

The revolution will not be televised!
 
Usually you can prefix the unwanted statement with the "no" keyword to undo the statement.

 
use the command !duplex auto or duplex half from within the interface.

you have your port set to access mode, but you also have switchport trunk native vlan 999...you can't have a trunking access port.

 
Thanks guys, The switchport trunk native was the last NA's attempt to control untagged frames. I hope the "no" command works for the qos and tx-queue that was left behind.
Thank you again..

The revolution will not be televised!
 
Stars...

/

tim@tim-laptop ~ $ sudo apt-get install windows
Reading package lists... Done
Building dependency tree
Reading state information... Done
E: Couldn't find package windows...Thank Goodness!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top