Delayed ringing on far end via VoIP trunks 2

[atascoman]

It takes about 5 seconds before the call completes and rings on the far end when I make a call over the H323 trunks. Is there a setting in the BCM to change this? I can hit # and the call completes immediately.

 

[DBrewsky]

What number are you dialing? Can you explain the setup in your Destination Codes and Routing for the number you dial?

 

[Dasheen]

Check dialing timeout.

If you go to Dialing Plan and General, you will see a box titled Global Settings. In it you'll see DN Length and Dialing Timeout

 

[atascoman]

I have destination codes setup for 3,4, and 5. Let's say I dial 5555. It goes out route 001 (VoIP trunks) into an NRS at the central site which then directs anything starting with a 5 to the correct endpoint.

 

[Deweyhumbolt]

It could be your Private DN length. It's waiting for an extra digit, so pressing # sends the call immediately.

Adversity is Opportunity

 

[Phnman]

Do you have H.245 tunneling on ? Much faster call setup and cut-thru if its on.

 

[pccal]

Deweyhumbolt has your problem solved.

 

[atascoman]

H.245 tunneling is off. Private DN length is 4 and we are doing 4 digit dialing.

 

[cook1082]

The route has to be private, if it is public then pressing the # key will eliminate the remaining digits that the system is waiting for to be dialed.

 

[atascoman]

Set the route to private. Still a slight delay, but nothing to write home about. All seemd good now.