Default User name and password in use!!! 1

[paulrdavey]

I Upgraded a sx2000 and during the process had to use the command sysuser read... Im sure this is why now I can only access the system using installer and sx2000. Can anyone tell me the command to make read/write. (I Followed the book completly to do the upgrade but cannot find where to make Write)ill need to set up the user assignment again. My upgrade went well but Its really not finished if i cannot write? thanks.

 

[MitelInMyBlood]

Issued from the ACTIVE plane:

VOL SET SYSUSER R/W

 

[MitelInMyBlood]

Likely too you'll find that the system time & date will need to be reset

DATE 2008-NOV-10
TIME HH:MM:SS

 

[paulrdavey]

Thank you very much I believed this was the command and so it is! Yes Date and time was updated after upgrade.