default IP gateway card

[andyfram]

I have a TDA-0484 VoIP Gateway card (in a TDA600) and I don't know the IP address was previously assigned to the card.

Is there a way to default the card so I can get back into the programming interface?

 

[cwc3]

have you tried to call tech support?

 

[andyfram]

They are closed for the next few days for the holidays.

 

[cwc3]

do you have port scanner program ? you know what ports the
gateway works on? its worth a try.

 

[TMcGuire]

I know how to on a tda100/200, I can only assume that the 600 is the same!
*Set the System Initialise Switch to the "SYSTEM INITIALIZE" position.
*CAUTION
Do not press the Reset Button nor turn the power off then on while the System Initialise
Switch is in this position. Doing so will initialise the PBX.
*Using the KX-TDA Maintenance Console, set the status of the card to OUS, then set it
back to INS.
*Return the System Initialise Switch to the "NORMAL" position.

This works for the TDA 30/100/200 Not sure for the 600 but I would try it anyway!!! (but that's me)
Hope this helps you
Terry