One of my customers has a very old DECT R2 system (europe).
After an internal move of the system the terminal port won't come up.(had problems before but would work after a couple of tries)
At first I'd expected the cable to have gone defective.
I made a new cable but still the port doesn't come up.
Does someone have a cable layout, so I can check if I did it right? as i had to pin mine out from a very unreliable cable.
Are there common faults with this system I should be checking for?
Does anyone know if there is documentation around somewhere,
as there doesn't seem to be any on the Avaya site.
After an internal move of the system the terminal port won't come up.(had problems before but would work after a couple of tries)
At first I'd expected the cable to have gone defective.
I made a new cable but still the port doesn't come up.
Does someone have a cable layout, so I can check if I did it right? as i had to pin mine out from a very unreliable cable.
Are there common faults with this system I should be checking for?
Does anyone know if there is documentation around somewhere,
as there doesn't seem to be any on the Avaya site.