Deblocking E1 card SL60

[Wachange]

Hi Colleagues,

I have a problem with my E1 card (TLU76) for ISDN QSIG connection. The line ports are blocked.
When I delete the lines from the Route the system deblocks the card. When i configure the lines of this route the system blocks the card. I have cleared all the blockings within the LIM and still the problem persist.
Please assist
Wachange

 

[whosrdaddy]

if the system blocks the board (SYSTEM BLOCK in CNLIP)
it means that there is a problem (hardware, line connection).

what do you have in ALLOP; concerning the TLU76?

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[Wachange]

I am getting following errors from ALLOP concerning TLU76

DEVICE BOARD FAULTY OR MISSING
DATE TIME ALP NOIF EQU BRDID
05DEC06 14:46:38 13 4 001-1-50-00 57

DIGITAL TRUNK, LOSS OF FRAME SYNCHRONIZATION
DATE TIME ALP NOIF UNIT EQU BRDID INF1
05DEC06 11:14:26 2 28 SLP60 001-1-50-00 57 256
DIGITAL TRUNK, LOSS OF SIGNAL
DATE TIME ALP NOIF UNIT EQU BRDID INF1
05DEC06 11:14:26 3 28 SLP60 001-1-50-00 57 256

 

[whosrdaddy]

a few questions :

a) I suppose the TLU76 has 32 timeslots available (so no board at 1-1-52)?
b) if a is yes, did you try another position (try another magazine if possible)
c) did you try another TLU76?

if you still have problems, the problem could be caused by faulty cabling or configuration...

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[Wachange]

The alarm messages must be showing when i han removed the board in the proocess of diagnosis.
Ok right now i have the PABX configuration that i used
example;-
CNBOE:BPOS=001-1-50; for erasing the card
CNHUI:BPOS=001-1-50; to reinstall the card.

Once the card up, the command (Before Assigning the lines to the card)

<CNLIPEV=YES;
LIM CONFIGURATION
LIM NUMBER 1
LIM CONTROL LIM CONTROL NUMBER OF SERVICE
SYSTEM SIDE SYSTEM STATE PCM-LINKS STATE LIM
A EXECUTING 0 ACTIVE
B NOT EQUIPPED
MEMORY MEMORY MEMORY SPARE
VOLUME SPARE AFTER PACKING
65535 KB 23430 KB 23430 KB
BUAR1 3821 KB BUAR2 2989 KB

DEVICE BOARDS
NUMBER OF
BPOS BOARDID INDIVIDUALS SERVICE STATE
001-1-22 77 16 ACTIVE
001-1-30 77 16 ACTIVE
001-1-32 77 16 PASSIVE
001-1-40 NOT EQUIPPED
001-1-41 NOT EQUIPPED
001-1-42 NOT EQUIPPED
001-1-43 NOT EQUIPPED
** 001-1-50 57 32 ACTIVE**

After configuring trunks to the route
After Assigns the trunks to the route and then run <CNLIPEV=YES;

ROEQI:ROU=158,TRU=1-1,EQU=001-1-50-01;
ROEQI:ROU=158,TRU=1-2,EQU=001-1-50-02;
ROEQI:ROU=158,TRU=1-3,EQU=001-1-50-03;
LIM CONFIGURATION
LIM NUMBER 1
LIM CONTROL LIM CONTROL NUMBER OF SERVICE
SYSTEM SIDE SYSTEM STATE PCM-LINKS STATE LIM
A EXECUTING 0 ACTIVE
B NOT EQUIPPED
MEMORY MEMORY MEMORY SPARE
VOLUME SPARE AFTER PACKING
65535 KB 23430 KB 23430 KB
BUAR1 3821 KB BUAR2 2989 KB

DEVICE BOARDS
NUMBER OF
BPOS BOARDID INDIVIDUALS SERVICE STATE
001-0-00 27 32 SYSTEM BLOCKED
001-0-10 102 32 ACTIVE
001-0-20 77 16 ACTIVE
001-0-22 77 16 ACTIVE
001-0-30 77 16 ACTIVE
001-0-32 NOT EQUIPPED
001-0-33 NOT EQUIPPED
001-0-40 NOT EQUIPPED
001-0-41 NOT EQUIPPED
001-0-42 108 16 ACTIVE
001-0-50 108 16 ACTIVE
001-0-52 NOT EQUIPPED
001-0-53 NOT EQUIPPED
001-0-60 106 16 ACTIVE
001-0-62 NOT EQUIPPED
001-0-63 NOT EQUIPPED
001-0-70 42 32 ACTIVE
001-1-00 27 32 PASSIVE
001-1-10 102 32 ACTIVE
001-1-20 77 16 ACTIVE
001-1-22 77 16 ACTIVE
001-1-30 77 16 ACTIVE
001-1-32 77 16 PASSIVE
001-1-40 NOT EQUIPPED
001-1-41 NOT EQUIPPED
001-1-42 NOT EQUIPPED
001-1-43 NOT EQUIPPED
**001-1-50 57 32 SYSTEM BLOCKED**