Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

dead port on C2950

Status
Not open for further replies.

damocles13

Technical User
Apr 27, 2009
26
US
I have a port on a Cisco 2950 that I have not been able to bring it back to life. Any suggestions as to how I can fix this and something about how to keep it from happening again would be appreciated. Thank you in advance...

They mostly come at night, mostly
 
Did you reset any settings for the one port? Anything in the logs regarding the port?
If you disable the port, then re-enable it, and it still does not work, I would leave it in an admin down state and label it as bad.

Not much you can do to dfix a bad physical port.
 
That is what I was afraid of, thank you anyway for your time.

They mostly come at night, mostly
 
Check the pins and see if they are bent . Otherwise reload the switch , if that doesn't fix it then its a hardware problem . Do you get a link light ?
 
Also make sure it is not in a error disable state . Verify with the show interface status " command.
 
Thanks, I'll check the pins then reload. I sure hope this takes care of the problem, budget cutbacks and all, I can't go off buying new switches....

They mostly come at night, mostly
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top