De-commision Call Pilot procedures?

[Telecomguy333]

Have made the migration to Cisco Unity Connetion and want to power down our Call Pilot currently connected to a CS1000. The CS1000 will continue to be our primary PBX but I want to remove system programming related to the Call Pilot.

my check list includes the following steps, can someone confirm?

1) LD 48
a) DIS_ELAN_xx (Call Pilot)

2) LD 17
a) OUT_ADAN_xx (for Call Pilot)
b) OUT_VAS_xx (for Call Pilot)

3) LD 48
a) OUT ELAN_xx (Call Pilot)

4 LD 23
a) OUT_ACD_xxxx (ACD for Call Pilot CDN)
b) OUT_CDN_xxxx (CDN for Call Pilot)

 

[KCFLHRC]

Your ELAN is built and outed in LD 17, not 48. You also need to out the 2008 sets before you out the ACD que.

 

[telebub]

And you'll OUT the CDN before the ACD queue.

 

[Telecomguy333]

So in order to out the ELAN in LD 17 I need to out the VAS first then the ADAN for Call Pilot?

 

[Telecomguy333]

Here is the config under the CFN in LD 22 for the ELAN 16, Call Pilot in regards to a specific order to remove. Does it matter which one I move first?

ADAN ELAN 16
CTYP ELAN
DES CALLPILOT
N1 512



VAS
VSID 016
ELAN 016
SECU NO
INTL 0001
MCNT 9999

 

[KCFLHRC]

I believe you have to remove the VAS first.

 

[gaibut]

what type of call pilot do you have?

 

[Telecomguy333]

We have a 1005R running 5.0 SU7 which was actually powered down and removed this past week.

 

[Reusser]

Need to do in this order - assuming Call Pilot is powered down

1 - remove sets
2 - removed CDN
3 - remove default ACDNs
4 - modify any dummy ACD or Phantoms TN to correct voice mail service
5 - removed VAS
6 - remove ELAN