DDI not working over a new PRA 1

[hurler]

Am I missing something simple???
Added a new PRI to a CS1000E (Suc5.0).
Can dial out no problem but can't get the DDI to work.
Central Office seems to be sending 4 digits (5800)as per printout below.
5800 is a valid extn number on the switch which I can dial internally.
The DDI calls are going to night service DN (don't have an attn) so assume routed as intercept.
I have checked the IDC (turned off and on) without success.
Any pointers?

DCH 12 UIPE_IMSG CC_SETUP_IND REF 00001002 CH 52 9 TOD 15:40:56 CK 0B99BDEF
PROGRESS: ORIGINATING END IS NOT ISDN
CALLING #:68711 NUM PLAN: E164 TON: UNKNOWN
CALLED #:5800 NUM PLAN: E164 TON: UNKNOWN
DCH 12 UIPE_OMSG CC_PROCEED_REQ REF 00009002 CH 52 9 TOD 15:40:56 CK 0B99BDF1
DCH 12 UIPE_OMSG CC_ALERT_REQ REF 00009002 CH 52 9 TOD 15:40:56 CK 0B99BDF2
PROGRESS: TERMINATING END IS NOT ISDN

 

[janaya]

what is your LDN0?

Check in LD 21

req: prt
type: ldn

If you don't have one, put a 4 digit (any 4 digit number) in the LDN0 field. Try that and it should work.

Just had the same thing a couple weeks ago. Had a customer that had numerous copper trunks and installed a PRI. This is an easy one to forget. Once I put in, calls came in.

Hope this helps.

John

 

[hurler]

John, your the man.
Problem resolved, thanks for speedy response.