DCH LD 96 And 60

[dirkfuzzbucket]

I have a link that is going up and down.
on one switch LD 96 stat dch I get

.stat dch
DCH 010 : OPER EST ACTV AUTO DES : ONRAMP
DCH 011 : OPER EST ACTV AUTO DES : TIE


Then in LD 60 to get loop channel info:


PRI2 LOOP 1 - ENBL
REF CLK: ENBL
TRACKING
SERVICE RESTORE: YES
ALARM STATUS: ACCEPTABLE
CH 01 - BUSY DID VOD * CH 02 - IDLE DID VOD *
CH 03 - IDLE DID VOD * CH 04 - IDLE DID VOD *
CH 05 - IDLE DID VOD * CH 06 - IDLE DID VOD *
CH 07 - IDLE DID VOD * CH 08 - IDLE DID VOD *
CH 09 - IDLE DID VOD * CH 10 - IDLE DID VOD *
CH 11 - UNEQ CH 12 - UNEQ
CH 13 - UNEQ CH 14 - UNEQ
CH 15 - UNEQ CH 16 - UNEQ
CH 17 - UNEQ CH 18 - UNEQ
CH 19 - UNEQ CH 20 - UNEQ
CH 21 - UNEQ CH 22 - UNEQ
CH 23 - UNEQ CH 24 - UNEQ
CH 25 - UNEQ CH 26 - UNEQ
CH 27 - UNEQ CH 28 - UNEQ
CH 29 - UNEQ CH 30 - UNEQ
CH 31 - DCH 10

WHY CAN I NOT SEE DCH 11 and the Loop?????? only 10???

 

[wdhb]

>ld 22
REQ prt
TYPE adan dch 10

ADAN DCH 10
CTYP MSDL
DNUM 11
PORT 1
DES Carrington_Lp_3
USR PRI
DCHL 3 this is the loop the d-ch is associated with

 

[dirkfuzzbucket]

DCH 10 is fine I can see the loop in the LD 60 prt.

What I can't work out is why I cant see the channels and the status when I stat in LD 60. How do I see the status of DCH 11??

 

[derbydave]

Do you have ITG Trunks between sites?
It could be that DCH 11 is used for that.
If you STAT the ITG card in LD32 it will show you the state of each channel.
If you don't know if you have ITG's or what slot they are in you could STAT each slot in turn.
It is obvious from the results when you find the ITG card.

We have a similar setup. A STAT DCH in LD96 shows DCH 14+15, 14 being ITG Trunks + 15 being ISDN PSTN Trunks.

Dave.

 

[dirkfuzzbucket]

Thanks that was the answer analogue trunks.......TA

 

[nortelhawk]

its analog trunks or ITG trunks ..........i think its ITG trunks as dch(a digitl trunk concept) can never get associated with any analog trunks.........