Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Date and Time
- Thread starter teclesoft
- Start date
obtsystems
Programmer
you can't, through the fires or second extension port (100-101) program 52 time and 53 date
- Thread starter
- #4
- Thread starter
- #5
- Thread starter
- #6
obtsystems
Programmer
it just goes down the page until its disappears into the archives
You can set the date and time on Manager E on a 3800 via the Online tool in the programming. Select Online in the transfer area of the tool and a seperate window will open with a virtual phone, the ext number of this device can be set in programming if needed for testing (found as the last port in the staions tab).
When the screen opens you will see the virtual phone display and all just do as normal *95 31994 tick 31994 tick 52 * set time hey presto!
When the screen opens you will see the virtual phone display and all just do as normal *95 31994 tick 31994 tick 52 * set time hey presto!
And if you don't have a Manager E, but you do have access to the network and there is a LIM or HG1500 card your HiPath which you can ping in the network.
Open a dosbox
typ; telnet x.x.x.x <enter> (x.x.x.x = ip address of hipath)
*95 31994 <enter> 31994 <enter> .....ect
Good luck...
___________________________________________
It works! Now if only I could remember what I did...
Dain Bramaged
___________________________________________
Open a dosbox
typ; telnet x.x.x.x <enter> (x.x.x.x = ip address of hipath)
*95 31994 <enter> 31994 <enter> .....ect
Good luck...
___________________________________________
It works! Now if only I could remember what I did...
Dain Bramaged
___________________________________________
- Thread starter
- #11
- Status