Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Data Line Utilization

Status
Not open for further replies.
odot

odot

Technical User
Apr 28, 2003
18
0
0
US
In our serial interfaces we add a statement 'bandwidth 1008'. Does this statement actually set the amount of bandwidth from telco? How do I know for sure I am getting the full amount from the telco?
 
Sort by date Sort by votes
Correct me if I am wrong, but I thought the Telco set that for you. Any thing you put was just kind of ignored.




I know what I know and that's all I know. What I don't know I'll find out.
 
Upvote 0 Downvote
On second thought it maybe used for the path cost determination.



I know what I know and that's all I know. What I don't know I'll find out.
 
Upvote 0 Downvote
bandwidth statements are used for path-cost determination.

if it's set at 1008, it may have been set that way to keep it just above another path (hence making it preferred). Or below of course.

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

woza
  • Locked
  • Question
GNS3: Delete the lines "transport preferred none"
Replies
1
Views
97
DrB0b
DrB0b
telemarksman
  • Locked
  • Question
ATA Cisco SPA122 not triggering single line courtesy phone ringer
Replies
0
Views
49
telemarksman
telemarksman
HollTel
  • Locked
  • Question
Cisco UC520 Shared Line issue
Replies
0
Views
39
HollTel
HollTel
AC427
  • Locked
  • Question
High response times during the night when there is very low utilization
Replies
1
Views
35
musurliman
musurliman
skk391
  • Locked
  • Question
Setting up a voice and data vlan on a switch
2
Replies
23
Views
209
VinceWhirlwind
VinceWhirlwind

Part and Inventory Search

Sponsor

Back
Top