Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Data Access Pages
- Thread starter ajp5453
- Start date
Good Afternoon!
Open the DAP in Design mode and select the "command" button control from the toolbox. Make sure the wizard is on when the button is selected. It will walk you through the process. The result is a button that will save and advance the existing DAP entries and clear the fields, ready for the next set of data.
I hope this helps.
Smuckers
Open the DAP in Design mode and select the "command" button control from the toolbox. Make sure the wizard is on when the button is selected. It will walk you through the process. The result is a button that will save and advance the existing DAP entries and clear the fields, ready for the next set of data.
I hope this helps.
Smuckers
- Status
Similar threads
- Locked
- Question
- Question
- Locked
- Question
