Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

D100 DECT Phone on 9.1 1

Status
Not open for further replies.

Techman1966

Vendor
Dec 21, 2013
14
US
Has anyone set up a D100 phone on 9.1 yet? I struggled for several hours trying to get the phone to connect. I did have it successfully connect twice only for the base to start rebooting after 10 or 15 minutes. The base was firmware 0.8.6 when on IPO 9.1. When I brought the unit back to my shop I installed it on IPO 9.0.4 in about 5 minutes the phone registered and stayed connected. I logged into the web interface and notice the firmware updated to 0.9.2. I will be taking the phone back on Tuesday to try to connect back to 9.1. Let me know if anyone has experienced this problem before.
 
I had the same problem with the D100. After connecting it to a 9.0 system I was able to do the firmware upgrade, but had to leave the unit on that system. Did it work for you on the 9.1 system after the upgrade?
 
Here is what I did to make this work. Connect the D100 to a 9.0 system. While connected log into the D100 and update the firmware to 0.9.6. If it doesnt work keep trying until the configuration shows 0.9.6 even after a D100 reboot. Once on 0.9.6 you can take the D100 to a 9.1 system and it sould work just fine.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top