Custom operators

[mcall]

after user changes custom operator from '0' to another ext they are unable to change back to '0'. Get error 'num can't be reached from this service'. Also get same error when trying to set operator to any num that is routed by DSC. Is it possible to configure system to allow setting custom operator to ext not local to user?

 

[bpg1]

hi mcall

yuo have to make an ext with the number you want on local switch,remove dsc make acd q. with number put number in oprator,change back out acd q. put in dsc,this could work there after.

 

[bpg1]

hi mcall

forget the 1 on,confused it with nite number,no operator have to be local,but you could setup nas in ld 86 or if there is no m2250 on switch use nite number to route call to other swicth with dsc

 

[mcall]

found prob in mm permissions. Opened permissions and now working