CS1000s and Audiocodes MP-102 FXS 1

[gcrumpler]

Having problems getting two ports configured. Sniffer traces show 2 line numbers being sent, but only one line will register with the SS. Any help or suggestion would be greatly appreciated.

 

[dlesap]

I did it last year. There is only 1 IP@ registered with NRS. Route 2 numbers to that Box in NRS Routing Entry tab. In ATA box, define numbers per port.
It's the same for MP104, MP108 or MP124

 

[gcrumpler]

delsap,

Thanks for your advise.
I checked and I have 2 NRS entries, but only one will register. Example: If I make ext 61111 channel one and 62222 channel 2 on the audio codes box, 61111 will register, but 62222 will not. If I configure 62222 as channel 2 and no channel 1 then 62222 will register.Both channel seem to work but no matter what order I put them in only one number will register on the SS at a time.

 

[dlesap]

How did you configured your NRS?
The ATA box have to be registered as Gateway endpoint using RAS endpoint. Don't use user entry tab, that's for SIP Phones...
When ATA box is configured and registered, use routing entry tab to define DNs to route to that box. DNs don't register..!!