CS1000m: How to force a call to a specific PRI

[wgocip]

Hi everyone,

If I have 2 PRI connected to CS1000M:
PRI #1 Carrier _1
PRI #2 Carrier _2

If I dial destination 1(NPA)-NXX-#### and the routing table is set to terminate on Carrier_ 1;
For troubleshooting purposes , how can I force a call to carrier_2 without changing the routing table.
Thank you.

 

[KCFLHRC]

You will have to have Carrier #2 defined in the RLI for calls to hit it.

 

[KCFLHRC]

Or you could dial the ACOD to Carrier # 2 Route, but that will not cause an outbound call to hit it through BARS.

 

[hawks]

agree with kcflhrc if it's just to troublshoot and make sure you can make calls out of that span you should use the ACOD of PRI #2.

 

[Singsiblaw]

I use a maintenance set to seize a channel on a specific PRI to make test call.