CS1000E Rack Mount Nortel - Possible to check power supply

[babytech2009]

Hello all,

Is there a way to check the Power supply on a CS1000E rack mount Nortel?
We have two out in the field but was not sure if there is a command prompt on the system that would be able to tell the status of the Power Supply's in the cabinets themselves.


Thank you in advance.

 

[KCFLHRC]

No command to check them and they are not field replaceable, you have to buy the whole chassis.

 

[babytech2009]

Thank you KCFLHRC.

 

[scotthdiv]

Depends on the type of cabinet - if they are MG1010 cabinets they are replaceable (dual power). If it's in the MG1000 chassis they are not.

 

[KCFLHRC]

Forgot about the 1010 cabinet, I assumed you have the NTDU14 and NTDU15 chassis.

 

[babytech2009]

We have the cart mount CS1000E not sure what model. I have to check with the vendor.
I can post as soon as I have the model number

 

[KCFLHRC]

What's a cart mount?

 

[babytech2009]

KCFLRC : its on a cart the PBX is a CS1000E. We want to pull the serial number from it.

 

[babytech2009]

We are on Vers. 7.6 Software. Wasnt sure if i can pull it from Ld 22 slt.
I dont see where i would find the serial number.

 

[KCFLHRC]

LD 22 , TID

 

[babytech2009]

KCFLHRC isnt that the tape id? My boss wants the serial number of the unit itself.



Ld 22

REQ TID

TAPE ID:
LOADED 318830824

 

[KCFLHRC]

That is the serial #

 

[babytech2009]

I thought it was the Tape ID for the call pilot information. the guide i have doesnt give much detail as to what it was for.

thank you.

 

[KCFLHRC]

Call Pilot doesn't have a Tape ID, but does have a serial #. The TID goes way back to the beginning of time, or at least 1979 when I started.

 

[babytech2009]

KCFLHRC... it goes back to then goodness. I didnt know i dont think our system has been up for that long.