I installed a CoRes R6 system and was given a new UTM E1/T1 card with clock controller.
I can't get the d-channel up.
My config is as follow:
MG slot4 - -
MG slot3 - UTM E1/T1
MG slot2 - -
MG slot1 - CPPM CoRes
MG slot0 - MGC Card (registered as 004 00)
I added the PRI under LD 17
I want to confirm that when asked for the:
"MG_CARD supl sh slot"
info, I enter the MGC number (4) shelf (0) slot (3)?
And under LD 14
I added a NEW TYPE tie
When asked for the "TN loop channel" is that "TN 3 0"?
And lastly under LD 73
FEAT syti
"MGCLK supl sh slot" is this "4 0 3" or " 0 0 3"?
I'm not sure if I have the PRI associated correctly with the MGC card, I have 96 DSP's and IPMG 04 00 in main MG.
Can someone explain the supl sh slot mappings and help me get the d-channel up.
Thanks
I can't get the d-channel up.
My config is as follow:
MG slot4 - -
MG slot3 - UTM E1/T1
MG slot2 - -
MG slot1 - CPPM CoRes
MG slot0 - MGC Card (registered as 004 00)
I added the PRI under LD 17
I want to confirm that when asked for the:
"MG_CARD supl sh slot"
info, I enter the MGC number (4) shelf (0) slot (3)?
And under LD 14
I added a NEW TYPE tie
When asked for the "TN loop channel" is that "TN 3 0"?
And lastly under LD 73
FEAT syti
"MGCLK supl sh slot" is this "4 0 3" or " 0 0 3"?
I'm not sure if I have the PRI associated correctly with the MGC card, I have 96 DSP's and IPMG 04 00 in main MG.
Can someone explain the supl sh slot mappings and help me get the d-channel up.
Thanks