Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CS1000 - Unable to connect TTY off Fiber Remote

Status
Not open for further replies.

billygrahamiii

Technical User
Jun 21, 2006
14
US
Hello! The following troubleshooting steps were taken below. At this point, the TTY on the far end is acting in half duplex (one way transmission). It has been suggested to try another MSDL card. Just wondering if anyone else has had this issue and been able to resolve. Thanks in advance!


Steps taken thus far:
LD 32
Disabled Controller Card
DSXP 12 ENTER
ENXP 12 ENTER
Disconnected Modem Eliminator
LD 37
STAT TTY ENTER
LD 22
REQ: PRT
TYPE: ADAN TTY 10
Verified Baud Rate 1200 (Changed to 9600 - still nothing)

Reconnected Modem Eliminator
LD 32
Disabled Controller Card
DSXP 12 ENTER
ENXP 12 ENTER
IDU Loop

BGIII
PosiTive Mindz
 
have you tried sending a test? ld 37 tty 10. You should get abc...123... "#$...ready for input
 
Are you using the nortel cable or did you make your own?
 
I assume you are talking about the local side since you mentioned msdl. Yes I would replaced the msdl but have you verified the dip switches?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top