Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CS1000 DHCp String

Status
Not open for further replies.

NY105

Technical User
Jul 6, 2011
41
US
Good Morning,

I need to know what the S4 DHCp string is on the DHCP server. I am trying to set up the full dhcp securemode and and partsecure.

DHCP Secure Mode The IP Phone follows the menu lock configuration
received from the Full DHCP string
• if SECUREMENU is present, you are prompted to enter a password
after you double-press the Services key
• if PARTSECURE is present, you are prompted to enter a password
whenever you select Local Diagnostics and Network Configuration
• if neither SECUREMENU nor PARTSECURE is present, then the menu
is not locked

Any help in setting this up would be greatly appreciated.

Thanks
 
Configuring Secure Local Menu through Full DHCP
Password protection is enabled during Full DHCP configuration if the
SECUREMENU parameter, or the PARTSECURE parameter are present at
the end of the S4 part of the Full DHCP string. If neither the SECUREMENU
parameter, nor the PARTSECURE parameter is present, password
protection is not enabled.
The SECUREMENU/PARTSECURE item is an optional parameter. If it is
present, then the full S4 string needs to be present, including the action
and retries. The S4 string is already present if the XAS support has been
configured through the DHCP. If XAS is not configured, you can still enable
password protection by setting the S4 IP address to 0.0.0.0 and by setting
the other fields to 0.
ATTENTION
With Full DHCP, the vendor-specific or site-specific options must be configured
depending on the customers DHCP server configuration.
For further information about configuring Full DHCP, see Converging the
Data Network with VoIP Fundamentals (NN43001-260).


the NTP listed does not provide any additional information.
 
This link might help:


I think you just need this part: Menu protection on, no XAS configured

"Nortel-i2004-A,147.19.11.70:4100,1,10;147.19.11.70:4100,1,5;0.0.0.0:0,0,0,SECUREMENU."

So, you just have to be sure that in the "S4 string" that you have SECUREMENU listed after a comma somewhere and be sure to still end the string in a period. We have ours working with a couple other options enabled or specifically disabled. We don't use SECUREMENU but it should work just fine.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top