Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CS 1000E rls 5.5 Expansion Cabinet

Status
Not open for further replies.

lexer

Programmer
Jun 13, 2006
432
VE
Hi

I've got a CS1000E 5.5 with CPPM (option cabinet), I'm installing a expansion cabinet in superloop 4 0, All cards in main cabinet (superloop 0 0) works ok, I've got analog extension cards (ANLG M/WLC) in the expansion cabinet (superloop 4 0), these cards are not working, I dont have dial tone.
The MGC in superloop 4 0 shows in the display 0 0 4 0.
I installed and configured the follwing for the MGC in superloop 4 0:
*I installed the DSP32 card in slot 2 in the MGC card
*the DSP32 has its TLAN ip address
*I added the 32 VGW channels for the DSP32
*I configured TDS loop and conference loop for the MGC 4 0.
*I configured DTR channels for MGC 4 0.

the status of the VGW and DTR channels for the DSP32 and the MGC 4 0 is IDLE, I used LD 32 for seeing the status.
I dont know If I'm missing something.


 
Thanks, xinnam, Yes I did, and the 32 DSP ports (VGW channels) appear IDLE when I see their status in LD 32
 
can you stat the falcs ??, i find i have to disable the cards, remove them, add them back in and then re'enable the cards to get them to work
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top