Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Create application DN in BCM 400.

Status
Not open for further replies.
202586

202586

Programmer
Dec 31, 2010
70
SA
I want to give a new DN to the new skillset, but i dont have any free application DN, as far as i know i shoud assing an Application DN to a skillset DN. How can i create more application DN in BCM 400.

Please help.....
 
Sort by date Sort by votes
go to resources-select application resources-select configure
add the amount off dns you require and allow extra.

By defaut you should have had at least 100 dns configured
 
Upvote 0 Downvote
Dear Snowman,
thanks for the reply, do i need to upgrade my element manager to see this option. i am using an old version of element manager, BCM 400 is patches with the latest patches.

 
Upvote 0 Downvote
I don't see the option Configure, but i see the same when i connect to BCM 450 from latest version of element manager, when i try to add the BCM 400 under the latest version of element manager i am getting an error cannot download cartridge...
any help will be appreciated.
 
Upvote 0 Downvote
Sorry i jumped in to quick.
I was refering to bcm450 were you can configure the resources.

As for EM download the version from the bcm you are working on.
I have had to do this some times.
 
Upvote 0 Downvote
So how can i do this in bcm 400.if i add ine more mbm will ut add applixation dn?
 
Upvote 0 Downvote
The 400 doesn't need application DNs for skillsets. You'll see them listed as inactive DNs. However, if you want to use one, just renumber it to your skillset CDN.
 
Upvote 0 Downvote
telcodog,
As per the task based guide you should assign Application DN ad skill set DN, I don't have any application DN under inactive DN. All the application DN is under Active DN, moreover these are already took by IVR port, CC and vmail , when checked from BCM Monitor, so now if i renumber it will it conflict with existing DN?
 
Upvote 0 Downvote
Doesn't matter, just assign one of your inactive DNs. It will work fine. In fact, all your inactive application DNs will show up there as well.

The danger of using an inactive set DN is not that it won't work, it's that someone who wants to add a new set may try to use the DN that you assign to the skillset. When that happens, you can expect a call from the call centre manager in about 2 minutes.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jsaad
  • Locked
  • Question
BCM 400 4.0 lights flashing
Replies
11
Views
247
exsmogger
exsmogger
jsaad
  • Locked
  • Question
BCM 400 3.7 vm no light
Replies
9
Views
209
jsaad
jsaad
Watch Out.
  • Locked
  • Question
BCM 400 VM down Can access Element Manager.
Replies
13
Views
303
Smoki
Smoki
BCoo
  • Locked
  • Question
BCM 400 Tel Set Reset PSWD CP
Replies
3
Views
140
curlycord
curlycord
LidLock Technologies
  • Question
BCM 200 R3 Disk Image 1
Replies
5
Views
843
curlycord
curlycord

Part and Inventory Search

Sponsor

Back
Top