Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CP on CICS

Status
Not open for further replies.
Jan 2, 2010
417
US
can I add a CP on a CICS ver DR 6.1 or a NAM 4.1 via a copper to fiber converter?
 
Are you saying you want to add another CP or is this a case of copper to fibre conversion?
 
well this customer had a cics dr 6.1. I gave a nam 4.1 and a cp 150 in stock. I wanted to know if dr 6.1 will support either unit?
 
Well I took a NAM 3.0 that I had in stock and added a DS-30 to it. I wanted to test it out before I installed it at the customers site so I set up my in house CICS 3.0 and it worked just fine.

I took the NAM 3.0 to the customers site installed it, they have 3 LOOP lines and 8 sets on a CICS v DR 6.1 and I heard the drive spin up and do it's normal beeping but then it never gave the final confirmation beeps and I could not log in. I get INACTIVE FEATURE on F981, F983, F985 etc.

I powered down both modules a few times and still the same thing. I would assume that DR 6.1 is higher than 3.0. Any suggestions?
 
it worked out ok but I noticed that I can not get it to FLASH HOOK got a centrex transfer. us it the nam sw version?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top