CP on CICS

[DaveThePhoneDoctorLV]

can I add a CP on a CICS ver DR 6.1 or a NAM 4.1 via a copper to fiber converter?

 

[parkgroup]

Are you saying you want to add another CP or is this a case of copper to fibre conversion?

 

[DaveThePhoneDoctorLV]

well this customer had a cics dr 6.1. I gave a nam 4.1 and a cp 150 in stock. I wanted to know if dr 6.1 will support either unit?

 

[curlycord]

yes CP 3.0 and NAM 4.1

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[DaveThePhoneDoctorLV]

Well I took a NAM 3.0 that I had in stock and added a DS-30 to it. I wanted to test it out before I installed it at the customers site so I set up my in house CICS 3.0 and it worked just fine.

I took the NAM 3.0 to the customers site installed it, they have 3 LOOP lines and 8 sets on a CICS v DR 6.1 and I heard the drive spin up and do it's normal beeping but then it never gave the final confirmation beeps and I could not log in. I get INACTIVE FEATURE on F981, F983, F985 etc.

I powered down both modules a few times and still the same thing. I would assume that DR 6.1 is higher than 3.0. Any suggestions?

 

[curlycord]

You need 4.1 NAM for 6.1 KSU

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[DaveThePhoneDoctorLV]

thanks.

 

[RikRodgers]

And make sure you're connecting them to station ports, not CO ports.

 

[DaveThePhoneDoctorLV]

it worked out ok but I noticed that I can not get it to FLASH HOOK got a centrex transfer. us it the nam sw version?

 

[curlycord]

No idea what you said at the end, start a new post if need if cant hook flash but plenty of posts alreay deal with that.

=----(((((((((()----=
curlycord

http://www.curlycord.com