I installed a Call Pilot 150 (3.1) on a MICS 7.1 last week and seemed ok. This morning it is inactive. Changed power sources but still won't boot up. Hooked up laptop and watched boot sequence through ProCom+ and it looks like it's getting stuck someplace near the start and just keeps repeating the beginning of the boot sequence. I don't fully understand what I'm looking at during the boot sequence so I'm afraid to make any changes. Is there a common problem with known fix that anyone is aware of? Please help if possible.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
CP boot sequence
- Thread starter Brutalis
- Start date
ironhorse17
Technical User
If it is new replaced it now, only had one in all the years with Norstar since the beginning and it was 3.1.
I've seen weird things happen when the IP address or gateway address is incorrect. Press any key as soon as the first screen appears. Default IP is 192.168.110.10. A gateway address is not necessary, but it should be 192.168.110.1.
Where does it get stuck and what error message are you getting?
Brian Cox
Oregon Phone
Where does it get stuck and what error message are you getting?
Brian Cox
Oregon Phone
- Status
Similar threads
- Locked
- Question
