Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Corel Draw X3: Back Minus Front shaping help

Status
Not open for further replies.

teamspirittees

Technical User
Sep 10, 2012
1
US
How would I do this?

I want to make a design all in one color.

It will look a lot like this image:
Do you see the letters at the top (Pack 900) and the bottom (Run with the pack!) how the cutout is a little larger than the letters. It makes the letter stand out more.

How would I do that?

If I just select both the words and the diamond and select Arrange > Shaping > Back Minus Front, that just cuts out the words. Adding the words back looks liek I did nothing.

If I try to use a border, I lose the border when I try the Shaping, I lose the border.

I've tried about everything I can think of with no luck.

Any ideas??

Thanks,

Joe
 
Hello Joe;
I see that it has been a while since your post but the site you are using to show the drawing is broken.
If you still need help up date it, or email it to me.

George
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top