Core LAN switch ports for CM 6.x

[copterride]

I have Duplex CM 6 on HP servers with 6 G450 gateways.

How many and what kind ports are connected to core cisco LAN switch?

My understanding is 2 eth0 ports for each CM server and 1 port for
each g450. Am i correct?

Also the two PRI's are connected to e1/t1 port of first 2 G450's in the rack and rest of the analog phones go to outside line via these
PRI's.

Thank you.

 

[Mitch672]

Each Server will take 1 LAN port, so you will need 2 LAN ports for your duplicated CM6 system.

Each G450 has (2) LAN ports, these can be setup in a redundant link, so you can use 1 or both ports, if you want port redundancy, so the answer their is 1 or 2, depending on if you want port redundancy or not.

PRI's only connect to T1/E1 circuits, these are MM710 cards if you have G450 media gateways, they have nothing to do with analog phones or outside lines. The DID's will ARRIVE on those circuits, but they are connected via either MM711 8 port analog/CO cards (for CO trunks), or by MM711 8-port analog/CO or MM716 24 port analog station packs (for analog stations in your office, such as FAX machines, modems or analog telehones/speakerphones)



Mitch

AVAYA Certified Expert

 

[copterride]

Thanks Mitch!

I also has CMS, SAL gateway server and integrated management FPM and Config severs.

I assume one lan port per server. Pls correct if wrong.

Also Can i setup HTTP on my DHCP server?

 

[phoneguy55]

I just got done with my first CM6 install. I have 2 LAN ports for each HP server. Remove either one of them and the system stays up and doesn't interchange. Works good.

 

[copterride]

Thanks phoneguy55 !

is that 2 ports for PE and duplication? OR 2 ports for PE to go into
separate switches for HA?

 

[phoneguy55]

2 ports for PE for each server. 1 connection to LAN switch 1 and one connection to LAN switch 2. So a total of 4 PE connections.
Then I used 1 cross over cable for duplication.

 

[copterride]

Thanks again!

Do yo know how many LAN ports i would need for 1. CMS and 2. SAL R610 server 3. AIM FPM and config servers?

 

[copterride]

phoneguy55,

Does both PE ports for each server have same IP address? Which
Ethernet ports you used as PE ports on DL360 HP server?

CAn i Have HA with CM Server1 PE port connected to LAN switch1 and CM Server2 PE port connected to LAN switch 2?

As per my understanding system domain (Dom-0) is physical connection to LAN switch and PE is logical link !

pls clarify

Thanks