Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Copy entire card command?

Status
Not open for further replies.

bzybnme2

MIS
Mar 1, 2011
16
US
I am trying to move a few cards to new ones so that sites that the main site is all contained in one cabinet.

We are going to be moving the phone system to a new location and the main site will end up as a carrier remote. If I can move the existing cards to spares in the same cabinet it would help.

Is there a command that will COPY the entire card?

Any info is greatly appreciated!
 
I don't want to move it, because I these phones are all active and I have to move the cables which will take ma a bit of time.

I want to have everything setup in advance and then after hours just move the cabling...

Is there a COPY command, not a MOVE command?
 
These phones may all be very different, and CPY 16 will result in all of them being the same as the CFTN (Copy From TN)

I think you're going to have to copy them all one by one, assigning a new KEY 00 DN to the destination TN - then go back and change the KEY 00 DN to equal it's mate on the old card.

--
Nortel Resources at GHTROUT.com
--
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top