Copy entire card command?

[bzybnme2]

I am trying to move a few cards to new ones so that sites that the main site is all contained in one cabinet.

We are going to be moving the phone system to a new location and the main site will end up as a carrier remote. If I can move the existing cards to spares in the same cabinet it would help.

Is there a command that will COPY the entire card?

Any info is greatly appreciated!

 

[bhassell2000]

ld 25
req mov



Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[bzybnme2]

I don't want to move it, because I these phones are all active and I have to move the cables which will take ma a bit of time.

I want to have everything setup in advance and then after hours just move the cabling...

Is there a COPY command, not a MOVE command?

 

[bhassell2000]

in ld 20 you can cpy 16

req cpy 16
type 3904

but you can't use the same DN, you will have to use a spare Dn and change it after

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[GHTROUT]

These phones may all be very different, and CPY 16 will result in all of them being the same as the CFTN (Copy From TN)

I think you're going to have to copy them all one by one, assigning a new KEY 00 DN to the destination TN - then go back and change the KEY 00 DN to equal it's mate on the old card.

--
Nortel Resources at GHTROUT.com
--