copy command error <code:0x3006b>

[verbo1]

Hello,

I'm trying to research this error code. I enter the following command at the CLI prompt:

(P8600:5# copy 10.100.31.2:/flash/boot.cfg 10.100.1.119:boot.cfg
ERROR: copy failed (code:0x3006b)

Does this indicate an error in syntax or with the tftp service?

Thanks for any help with this matter.

 

[dane775]

I looked at your syntax and it's fine.

I've been having problems TFTPing from 8000s lately, but every time it's come up I've been too busy to troubleshoot it. I've had to TFTP to a WAN router connected directly to the Passport and then pull it from there.

If I get a minute (many fires today) I'll see if I can figure out what's going on. I've got a switch I use to look into this.

 

[verbo1]

Thanks for your effort. I've heard that that Nortel's TFTP server implementation can be a bit of a challenge.