Converting analogue - digital extension

[madmonkeys]

Hey guys,

I have an analogue extension (type 500) which i need to change to a digital (type 2216).

I have outed the analogue extension and am able to copy the digital phone of a similar setup to the one required, I am able to do

CPY 1
TYPE 2216
CFTN 5 12
DES 359
TN 18 02

Then I am getting error sch0126 which means "Station type conflicts with existing card".

I would be very greatful on any advice on how to overcome this.

Thanks in advance
Nigel

 

[3tdp33ler]

I gues you'are configuring an analogue port for a digital extention.
You need ? Digital Line Card port to create and connect a digital set.

 

[madmonkeys]

Thnks for the response 3tdp33ler.

How do i identify a free digital line card port?

Nigel

 

[strmwalker]

madmonkeys... use LD20 req:luvu that will show you the unused voice units look for your digital ports.make
sure you don't use one of your meridian mail ports if you have mermail.

strmwalker

 

[3tdp33ler]

You can try to do it with LD20:
REQ LUU <-- Lists Unused Units
TYPE 2000 <-- To see unused digital voice ports (marked VCE)

 

[sandyml]

To add to the above -- make sure you use units 0-15, and not in the 16-31 range.

 

[johnpoole]

if you use
ld 20
luvu
2000 (for all dig voice ports 500 for analog ports)

you will only see a list of unused digital voice units.. that command does not list 16-31... if you stat a card

ld 32
stat 5

that will tell you what type stations are on that card... you have to copy from a dig to a dig and from an analog to an analog..

john poole
bellsouth business
columbia,sc