continue expansion LIM in a GS

[wfhy]

Who has been done continue expansion some LIM in a GS in BC12 SP5? Is there any tips and attension? I need it.

Discription in ALEX as follows:
Addition of LIM (without initial loading) can only be done to exchanges with a group switch.

I remember that continue expansion LIM from 7LIM TO 8LIM and over 11LIM in BC8 can be done.

Thank You!

 

[patcher]

Are you planning to do it? It seems you don't have any idea and I think its better someone who know should do it. There are plenty of preparation. You need the BC12 lim disposition table(XLIM). You had to edit it and load only the units existed in the switch. INL can be done by DUSII.
LIM can be added as long as you have GS. There is no restriction on how many LIM, example I can add LIM3 in a 2LIM with group switch or the 4th LIM in a 3 lim system. It doesn't had to be 11 LIM. There are several data to put back and you see all instructions in ALEX(Addition of LIM).

 

[wfhy]

Patcher,

Thank your reply. I am going to add some LIM on existing MD110.

I have enough experience for expansion LIM with INL. Before BC8 vesion, I always power off old LIM, after conecting some new added LIM, power on all LIM and GS and recreat new MD110 system using INL. This is that different program
unit such as DEMA, DEMB, DEMC.....DEMZ loading different LIM.
After BC10 vesion, no those. So I am looking for a easy way.

wfhy