Connection to Definity via RS-232

[CyMac6poD]

Hi,
i have some problems with connection to DEFINITY system. Definity CSI with TN2402 proccessor. I trying to connect via RS-232. I take DTE-DCE cable and connect it with J3-TERM output connector. Then I start ASA(because i haven't DSA)and start emulation. The results - in attachment. it's simply empty window of emulator. what am i doing wrong?
If someone can share DSA install - it'll bee very appreciated.
I have tried Putty and Tutty and the results were same - only empty window of emulator. Pressing any keys, typing commands does not have any results.

 

[CyMac6poD]

almost forget. the station doesn't work. but worked 2-3 years ago. since that time it was at storage and now i must resurect it. at power up LEDs on plates are red. but i know that it was working so some software must be present on station.

 

[CyMac6poD]

all is done. it was a bad port on my PC. the station is live? but in SPE-Down mode. i think i'll have many "pleasure" with it.