CONNECTION OF IP OFFICE ONE BRANCH TO ANOTHER BRANCH..

[ra1ma2]

morning guys?

I connected the IP office to one of institute said that they have
already creat VPN ,
I tried a lot to configure the ip but their ip phone alrady have pick
the ip from pbx

one of the branch is 10.13.10.1
the other branch is 10.13 .8.1

but the ip phone are okay....
i configured to LAN 1 10.13.8.30 to one of side are okay and
other side
Iconfigured to LAN 1 10.13.10.30 are okay the ip phone pick from
the PABX.....

and I created the h323 to one of side and put some information try to
ping the pabx of aother side I can"t see ...it but I see the one side of Pbx one side try to ping it does n"t show any thing
but the other side is okay.. I set the IP address on LAN 1 .....

 

[azrael2000]

Hi there.

Are you trying to SCN the offices?

If so, you will have to make sure there is connectivity between the offices on a network (a given I grant you, but still thought I would mention it.)

Then on the offices you will have to create SCN links between the two offices. When you create the SCN line (H.323 on the older versions, an IP Office SCN Line on the newer ones). For the field information, if you press F1 when you are in the field you have questions on, a contextual help will show up).

Then you will have to make sure you have an IP route for each office. Again, contextual help is your friend.

Hope this helps.

Regards