I'm trying to connect carrier B to Carrier A. There is a cable with a large connector from Carrier B but I can't see where this is supposed to be connected to on Carrier A. Does anyone know this?
If your carrier B is Processor cabinet than you have to connect ICC A, ICC B and ICC C cabels and the TDM bus cabel.
If is just port cabinet that you have to unplag the bottom TDM BUS Terminator and plug there the TDM BUS cable.
Hope this will help you. MKD
Look at the back there is a white line in carrier A that is marked TDM, most likely there is a terminator installed right now, that is where you're cable should go.
The terminator should then be installed in the B carrier.
PS in the B carrier there is a jumper somewhere in the bottom right that tells the carrier if it is a B, C or D carrier Please let me know if the information that was provided is helpfull.
Edwin Plat A.K.A. Europe
Make sure you connect the TDM Terminator correctly, if not you WILL fry the Terminator and possibly more.
the back of the carrier is clearly marked tdm lan/wan.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.