connecting Option 11c to matra (EADS) M6501L using PRI

[droguer03]

Sorry, I'm looking for help here. Any one has ever connected a Meridian 1 Option 11c against a Matra M6501-L using ISDN PRI ? I tried several protocols - ETSI, Numeris, etc. but no luck. I cannot get the d-channel up.

I'll appreciate your help

P.S. Somebody told me to use QSIG, but the Meridian 1 is not eqquiped with that facility, only ISDN EURO and North America

 

[johnpoole]

qsig is a pkg option, you should get the d up even if you need qsig for full intergration, you might not gets all features without qsig. what are the chn params in your remote device? post those and someone here may spot something. haven't used it, but usually able to find common ground between a new device and something i have played with.. (cisco, fugi, nec rolm siemmons mitel exc)

john poole
bellsouth business
columbia,sc

 

[hawks]

What about the cable that you are using?

 

[droguer03]

thanks for your help. I don't think the problem being connectivity or cable, we're using a pair of Coax BNC cables, for E1 unbalanced/75ohm. Both systems (matra and Nortel) appear to see the link up, with no line errors or so. BUT the d-channel between both never goes up

 

[Avaya911PLM]

When you try to force the DCH do you see RLS WRONG MODE?
You may have the NET / USR set incorrectly on the DCH provisioning.

--
Fletch
Visit the Nortel Technical Support Portal at:

http://www.nortelnetworks.com/support