Connecting OpenStage Key Module 15

[plokijuh]

Hi.

I have a problem with connecting connecting OpenStage Key Module 15 to OpenStage 15T on HiPath 4000 V7.

I know that to connect BLF (Busy Lamp Field 40) you need to activate the setting in SBCSU command
CHANGE-SBCSU:STNO=XXX,OPT=OPTI,BLF=Y;

Then you just need to check it
DISPLAY-SBCSU:STNO=XXXX,TYPE=OPTIDAT;

If BLF connected properly then it appears.
+------ INDIVIDUAL DEVICE DATA ----------------OPTIP500---XXXX-------------+
| |
+----PHONE-ID / OPTION-ID-------------+-EXT-+--ASSET-ID---+-SW VERS-+-TEST-+
| PART NUMBER | | KEYBD TYPE | BOOT-SW |HWVERS|
+----SOFTWARE VERSION (LONG FORMAT)---+-----+-------------+---------+------+
| OPENSTAGE 40 T | 0 | FF FF FF FF | | 0 |
| V2.R0.12.0TDM C01 | | | | |
| S30887-S9109-A291-5 | | | | |
| OPENSTAGE BLF | | | | 0 |
| V1.R0.14.0BLF C01 | | | | |
| S30887-Q9437-A291-* | | | | |
+-------------------------------------+-----+-------------+---------+------+

Is there anything equal to connect OpenStage Key Module 15?

Thanks.

 

[OKACHA]

hello;

i think that you should first use

CHANGE-TAPRO:STNO=xxxx,STD=60;

and then conect your module in your display the phone is detected as
| [highlight #CC0000]OPENSTAGE 40 T[/highlight] | 0 | FF FF FF FF | | 0 |

best regards
okacha

 

[plokijuh]

Thanks for the answer.

Assigning STD is the first what I did. OpenStage 15 has 8 buttons.

The OpenStage Key Module 15 has its own software version and phone (subscriber's number) need detect it first.

 

[sbcsu]

You are not connecting a BLF - you are connecting a DSS panel.
CHA-SBCSU:STNO=XXXX,REP=XX;
Where REP is the number of key modules you are adding.

 

[plokijuh]

Thank you sbcsu.

That exactly what I needed.