It's been a while and I can't remember where to punch down the pair from the Norstar Flash 2 to the block for a Norstar PLUS Compact ICS to connect voicemail to the system. Don't have the installer manual and I didn't find it in any of the manuals we have. Any help for the memory loss would be greatly appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Connecting a Norstar Flash 2 system to a distribution block
- Thread starter aks1036
- Start date
vtphoneguy
Vendor
The Flash is connected to an unused digital station port.
- Thread starter
- #3
vtphoneguy
Vendor
Verify that you have a working port connected to the Flash.
Make sure Set Relocation is turned off
Unplug cable from the Flash and plug it into a digital phone
If the phone works then plug back into Flash and reboot both the CICS and Flash
Make sure Set Relocation is turned off
Unplug cable from the Flash and plug it into a digital phone
If the phone works then plug back into Flash and reboot both the CICS and Flash
allworxguy
Vendor
If this is a Flash 1.9 or higher you have to start with F903
Marv ccna
Sales, Installation & Service for Norstar, BCM, Samsung & Allworx Serving Ottawa and Eastern Ontario since 1990
Marv ccna
Sales, Installation & Service for Norstar, BCM, Samsung & Allworx Serving Ottawa and Eastern Ontario since 1990
vtphoneguy
Vendor
Excellent point Marv. The OP stated the system was working but got moved so I assumed it had already been initialized...of course it could have defaulted...
- Thread starter
- #7
- Status
Similar threads
- Locked
- Question