connected devices

[aastratech]

is there a command line on Md110 BC12 that will display if devices are connected to EL28 and EL29 boards?

many thanks

 

[inlsp05]

CNBIP:LIM=X,BRDID=87; FOR ELU29
CNBIP:LIM=X,BRDID=77; FOR ELU28

PG4E

 

[aastratech]

THAT ONLY SHOWS BOARD REVISION STATE, NO DEVICES ARE SHOWN..
I NEED TO SEE IF THERE ARE ANY PHYSICAL CONNECTIONS , WASNT SURE IF bldp WAS AN OPTION OR A BETTER WAY TO SEE THIS

 

[aastratech]

*BLFDP SORRY

 

[snor]

Hi,
BLFDP; sounds good to see, if there are digital Devices equipped or not (ELU28)
Unequipped analog devices (ELU29) will not be shown with BLFDP. (manuell action needed, line by line)
best regards,
Norbert

 

[Geka]

syedp:bpos=1-1-20;

 

[himdp]

To determine which devices are configured on the ELU boards use the following-

SYEDP:LIM=ALL,TYPE=EL6; ! FOR ELU29 !
SYEDP:LIM=ALL,TYPE=KL1; ! FOR ELU28 !
SYEDP:LIM=ALL,TYPE=EL8; ! FOR ELU28 !
SYEDP:LIM=ALL,TYPE=OL1; ! FOR ELU28 !

These will not show which have devices avtually connected however.
As snor suggested, BLFDP will show where digital devices are configured but not connected. Analogue extensions will not show in this print and you must trace the wiring to see.