Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

connected devices

Status
Not open for further replies.

aastratech

Technical User
Aug 15, 2006
136
GB
is there a command line on Md110 BC12 that will display if devices are connected to EL28 and EL29 boards?

many thanks
 
CNBIP:LIM=X,BRDID=87; FOR ELU29
CNBIP:LIM=X,BRDID=77; FOR ELU28

PG4E
 
THAT ONLY SHOWS BOARD REVISION STATE, NO DEVICES ARE SHOWN..
I NEED TO SEE IF THERE ARE ANY PHYSICAL CONNECTIONS , WASNT SURE IF bldp WAS AN OPTION OR A BETTER WAY TO SEE THIS
 
Hi,
BLFDP; sounds good to see, if there are digital Devices equipped or not (ELU28)
Unequipped analog devices (ELU29) will not be shown with BLFDP. (manuell action needed, line by line)
best regards,
Norbert
 
To determine which devices are configured on the ELU boards use the following-

SYEDP:LIM=ALL,TYPE=EL6; ! FOR ELU29 !
SYEDP:LIM=ALL,TYPE=KL1; ! FOR ELU28 !
SYEDP:LIM=ALL,TYPE=EL8; ! FOR ELU28 !
SYEDP:LIM=ALL,TYPE=OL1; ! FOR ELU28 !

These will not show which have devices avtually connected however.
As snor suggested, BLFDP will show where digital devices are configured but not connected. Analogue extensions will not show in this print and you must trace the wiring to see.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top