Connect using WinSPM v5

[MASolutions]

Folks,

I am trying to connect to an Magix system. We follow the steps in connecting to the remote site, configure the modem speed to 2400, manual setup, get modem tone from an analog set connected into the dial-up modem, get prompted with the password (which we enter the default and will not reveal as it is all over tek-tips) and then get a disconnected prompt.

Is there a step or configuration we're missing?

 

[gknight1]

try here

http://www.tek-tips.com/threadminder.cfm?pid=689