CONNECT CISCO 3745 WITH MD110 (REL.10)

[demys80]

Good morning,

When I call from an ERICSSON phone to CISCO IP PHONE throught Q-SIG link I have the following problem: On Cisco Display I can't see the calling number of the source MD110 phone!!!

Follow up the our MD110 configuration:

<rodap:rou=99;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
99 SL60 H'00000300 H'15400000 H'06300010 NO

END

<roCap:rou=99;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
99 411000000070001 4 3110000011 0 30 20 00151515 111110000031 111111

END

<RODDPEST=86;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
86 99 1505100000000250000 0 3 0

END

Anyone can help me please,thanks a lot,have a nice day!

 

[rfpui]

My first suggestion is to change ADC to
ADC=1606100000000250000;

 

[demys80]

Ok,thanks I'll try!!!

 

[demys80]

I have tried,It's not the correct solution!!!

 

[mdman]

I think you need at least version 3.4 something on the Cisco side in order to get this to work.
Try using ISO by setting VARI to 15440000
The change suggested by rfpui only changes the Type OF Number from unknow private to local private. That should not make a difference for calling name.
By the way bit D5 of the ADC parameter shouldn't be set to 1. That is only good when you are connected 2 Ericsson PBX's together.

 

[demys80]

The solution of problem is: set ADC of digital or analog (kscac or excac)extension at 000000010.
Thanks child,have a nice day!