Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Configuring VLANs on multiple Catalyst 2950 switch 1
- Thread starter Soha
- Start date
-
1
- #2
terrywilson
MIS
Didn't look very closely but it looks verly similar to the setup of ours...
- Thread starter
- #3
I have tried the link mentioned in your reply. However, my switch does not accept the
switchport trunk encapsulation isl
What is the command that specifies the trunk encapsulation method on the 2950 switch?
when I type in:
switchport trunk ?
it gives me three options, that are:
allowed ..................
native .....................
pruning .....................
switchport trunk encapsulation isl
What is the command that specifies the trunk encapsulation method on the 2950 switch?
when I type in:
switchport trunk ?
it gives me three options, that are:
allowed ..................
native .....................
pruning .....................
eurobadger
Technical User
Hi
According to this article:
the 2950 does not support ISL
Sorry
EB
According to this article:
http://www.cisco.com/en/US/tech/tk389/tk390/technologies_configuration_example09186a00800949fd.shtml
the 2950 does not support ISL
Sorry
EB
- Status
Similar threads
- Locked
- Question