Configuring Cisco ASA5510 with VPNRemote on 5620SW phones

[kmerck]

Does anyone have the configuration code needed for an ASA 5510 to use for a 5620 with VPN software?

 

[amriddle01]

http://www.avaya.co.uk/emea/en-us/resource/assets/applicationnotes/ASA-h323-Stn.pdf

may help a little also you will need this entry:
policy-map global_policy
class inspection_default
inspect pptp
also there should be no entries here:
Configuration > Firewall > Objects > Inspect Maps > H.323
Configuration > Firewall > Objects > Class Maps > H.323
if there are remove them.

ACS - IP Office Implement

"I'm just off to Hartlepool to buy some exploding trousers

 

[kmerck]

Thanks for the quick response. I am using an IP Office and the configuration references Communication Manager. Do you have IP Office setup guide?

 

[amriddle01]

That is the only document there is as far as I know, that was mainly to give you an indication of what's required in the Cisco box

ACS - IP Office Implement

"I'm just off to Hartlepool to buy some exploding trousers

 

[Maxwell1001]

amriddle01 is the VPN Tunnel no IpSec, if so does the Policy Map not apply as it is not inspecting Ipsec or h.323 packets, only PPTP packets,

the reason i ask is we have a number of VPN phones setup and working fine but on one site sometimes the VPN phones get stuck in a reboot loop failing at IKE Confguration error and then just come back up

regards

ACA - IP Office
ACS - IP Office